Unsupported Platform Alert: Troubleshooting Intel Serial IO Driver Installation

While installing Intel® Serial IO host controller driver, if you get error message “The setup program ended prematurely because of the following error: This platform is not supported” , don’t worry. The error can be easy to fix. The error would occur if I2C is not enabled in BIOS. To resolve the problem, just enable I2C in BIOS.

Please refer to the guide below how to enable I2C in BIOS.

1. Press F2 during boot to enter BIOS Setup.

2. Go to the Advanced > Devices > Onboard Devices menu.

On the Legacy Device Configuration pane:

3. Set Pins 13/14 to I2C0_SCL/I2C0_SDA .

4. Set Pins 15/16 to I2C1_SCL/I2C1_SDA .

5. Press F10 to save and exit BIOS Setup.

After enabling I2C in BIOS, you can install the Intel® Serial IO host controller driver again.

I2C is enabled for the Low Speed Custom Solutions Header. So if you don’t wish to use the Low Speed Custom Solutions Header, you don’t need to install this driver.

If you useDriver Easy to install this driver and meet this problem, follow the guide here and the problem will be resolved. Alternatively, you can skip to install this driver by clicking the arrow button and selectingHide this Update .

Easy and Safe Partition Software & Hard Disk Manager